Resetting a Garage Door Repair Auburn CA after manually opening it is a simple process that you can easily do by following a few steps.

In this guide, we will walk you through the process step-by-step to make sure that you do it correctly and safely.

Step 1: Disengage the Garage Door Opener

The first step is to disengage the garage door opener so that it doesn’t interfere with the process. You can do this by pulling the emergency release cord or lever. This cord or lever is usually located near the top of the garage door track or on the garage door opener itself. Pulling this cord or lever will disengage the trolley from the opener carriage and allow you to manually operate the garage door.

Step 2: Open the Garage Door

Once you have disengaged the garage door opener, you can manually lift the garage door. Start by standing inside the garage with your back to the door and lift the door by grabbing the handle or the bottom panel. Lift the door until it is fully open.

Note: If the garage door is too heavy for you to lift, do not attempt to do so. You should call a professional to inspect and repair the door.

Step 3: Secure the Garage Door

Once the garage door is fully open, you need to secure it in place to prevent it from falling. You can do this by placing a clamp on the track just below the bottom roller on both sides of the door. This will keep the door from moving and keep it in the fully open position.

Step 4: Reset the Garage Door Opener

Now that you have manually opened and secured the garage door, it’s time to reset the garage door opener. This step may vary depending on the type of garage door opener you have, so it’s important to refer to the manufacturer’s instructions for specific guidance.

In general, you will need to follow these steps:

  1. Re-engage the garage door opener by pulling the emergency release cord or lever back towards the opener carriage. This will re-connect the trolley to the carriage.
  2. Press the button on your garage door opener remote or wall control to close the door. The garage door should start to close, but then stop and reverse direction. This is a safety feature that ensures the door doesn’t close on something or someone.
  3. Wait for the garage door to fully open again. Once it is fully open, press the button on your garage door opener remote or wall control to close the door. This time, the door should close all the way without stopping or reversing direction.
  4. Test the garage door opener a few more times to make sure it’s working correctly. If you notice any issues, refer to the manufacturer’s instructions for troubleshooting guidance.

Step 5: Remove the Clamps and Test the Garage Door

Once you have reset the garage door opener, you can remove the clamps from the track and test the garage door to make sure it’s functioning properly. Stand outside the garage and use the remote or wall control to open and close the door a few times.

Conclusion

Resetting a Garage Door Repair Auburn CA after manually opening it is a simple process that you can easily do yourself. Just follow these steps, and you’ll have your garage door opener working again in no time. If you encounter any issues during the process, refer to the manufacturer’s instructions or call a professional for assistance.

Garage Door Repair Service in Auburn

10868 Combie Rd, Auburn, CA 95602

530-203-5813