As a homeowner, I recently found myself in the position of needing to replace the garage door spring on my own. While I was a bit nervous about tackling this task, I did my research and gathered the necessary tools to ensure I could complete the project safely and effectively.

By following Garage Door Repair Hollywood FL, I’ll share the steps I took to replace my garage door spring, as well as some tips for anyone looking to do the same.

Step 1: Gather Information

Before I began the process of replacing my garage door spring, I did some research to ensure I understood the basics of how it works and what tools I would need. I learned that there are two types of springs commonly used in garage doors: torsion springs and extension springs. Torsion springs are mounted above the door, while extension springs are mounted on either side of the door. I also learned that it’s important to determine the size of the spring, which can be found on the spring itself or by measuring the diameter of the spring.

Step 2: Release Tension

Once I had gathered all of the necessary information and tools, I began the process of replacing my garage door spring. The first step was to release the tension in the old spring. To do this, I used a winding bar to turn the spring a quarter turn in the direction that the spring is wound. This released the tension in the spring and made it easier to remove.

Step 3: Remove Old Spring

Next, I secured the spring to the track or garage door frame using a clamp or vice grip pliers. This prevented the spring from flying off once it was removed. I carefully removed the bolts or screws that held the spring in place and then removed the spring from the garage door.

Step 4: Install New Spring

I then took the new spring and attached it to the garage door frame using the bolts or screws that held the old spring in place. I made sure the spring was properly aligned and tightened securely.

Step 5: Wind the New Spring

Using the winding bar, I wound the new spring in the opposite direction of the old spring. I wound the spring until it was tight and the door was balanced. It’s important to wind the spring the correct number of times based on the weight of the garage door. In my case, I used the manufacturer’s guidelines to ensure I wound the spring correctly.

Step 6: Test the Door

After winding the new spring, I tested the garage door to ensure it was functioning properly. I opened and closed the door several times to ensure it was balanced and operating smoothly. I also made sure to visually inspect the door and spring to ensure there were no signs of damage or wear.

In conclusion, as stated in Garage Door Repair Hollywood FL, while replacing a garage door spring can be a bit intimidating, it’s a task that can be completed by homeowners with the right tools and knowledge. By taking the time to gather information and follow the proper steps, I was able to replace my garage door spring safely and effectively. If you’re considering replacing your garage door spring, be sure to prioritize safety and take the time to fully understand the process before beginning.

Hollywood Garage & Overhead Door Co.

6592 Taft St, Hollywood, FL 33024, United States

954-716-8336