Garage Door Repair Services springs play a crucial role in the proper functioning of your garage door. Over time, these springs can wear out or break, requiring replacement. While replacing garage door springs can be challenging, with the right tools and knowledge, you can accomplish this task safely and effectively.
In this guide, we will walk you through the step-by-step process of replacing garage door springs.
Note: Replacing garage door springs can be dangerous due to the high tension involved. If you are unsure or uncomfortable with any step, it is recommended to hire a professional garage door technician.
Tools and Materials Required:
- Safety glasses
- Work gloves
- Adjustable wrench
- Socket wrench set
- C-clamps or vice grips
- Steel rods or winding bars
- New garage door springs (make sure to purchase the correct type and size for your specific garage door)
- Ladder or step stool
- Measuring tape
- Marker or tape
Step 1: Ensure Safety Precautions Before starting, put on safety glasses and work gloves to protect yourself from any potential injuries. Disconnect the power supply to the garage door opener to prevent accidental activation while working.
Step 2: Identify the Type of Garage Door Springs There are two common types of garage door springs: torsion springs and extension springs. Torsion springs are located above the garage door, while extension springs are positioned on both sides of the door. Identify which type of springs your garage door has before proceeding.
Step 3: Release Tension on Torsion Springs For torsion springs, it is crucial to release the tension before removing them. Locate the winding cone on the spring, usually positioned at the center shaft. Insert a steel rod or winding bar into one of the holes on the winding cone and slowly unwind the spring. Use a second winding bar to secure the tension and prevent the spring from unwinding unexpectedly. Repeat this process for the second torsion spring if applicable.
Step 4: Disconnect Extension Springs For extension springs, start by securing the garage door in a fully open position using C-clamps or vice grips on the track, ensuring it cannot close unexpectedly. Disconnect the safety cables attached to the springs and carefully remove them from the brackets.
Step 5: Remove Old Springs Using a socket wrench, remove the bolts securing the old springs to the brackets or center shaft, depending on the spring type. Once the bolts are removed, carefully detach the springs from the garage door.
Step 6: Install New Springs Attach the new springs to the brackets or center shaft using the bolts you removed earlier. Ensure they are securely fastened.
Step 7: Wind Torsion Springs (if applicable) If you have torsion springs, follow the manufacturer’s instructions to wind them in the opposite direction of how you unwound the old springs. Use the steel rods or winding bars to wind the springs, ensuring they are tightly wound and under tension. Be cautious and follow the recommended number of turns specified by the manufacturer.
Step 8: Reconnect Extension Springs (if applicable) For extension springs, reattach them to the brackets, ensuring they are properly seated. Reconnect the safety cables and remove the C-clamps or vice grips securing the garage door.
Step 9: Test the Garage Door Carefully remove any tools or equipment from the garage door area. Slowly and manually operate the garage door several times to ensure smooth movement and proper spring tension. If necessary, make adjustments to the tension by winding or unwinding the springs slightly.
Conclusion: By following this step-by-step guide, you can replace your Garage Door Repair Services springs effectively. However, remember that working with garage door springs can be dangerous. If you are unsure or uncomfortable with any step, it is always best to seek assistance from a professional garage door technician to ensure your safety and the proper functioning of your garage door.
EDM Garage Doors
596 Richard Brown Blvd, Volo, IL 60073, United States
1-847-416-3036
Leave a Reply