To program the garage door opener in your Honda Odyssey, follow these steps from Garage Door Repair Palm Desert CA:

  1. Prepare your garage door opener: Make sure you have the remote control or keypad for your garage door opener handy. Also, check the garage door opener itself for any programming buttons or switches.
  2. Locate the Homelink buttons: In your Honda Odyssey, the Homelink buttons are usually located on the ceiling console, above the rearview mirror. There are three buttons labeled “I”, “II”, and “III”.
  3. Clear existing codes (if necessary): If there are already codes programmed in the Homelink system, you may need to clear them before programming a new one. To do this, press and hold the two outer Homelink buttons (I and III) simultaneously for about 10 seconds, until the indicator light starts flashing rapidly. Release the buttons to clear the existing codes.
  4. Put the Homelink system in programming mode:a. Hold the remote control close to the Homelink buttons in the Honda Odyssey.b. Press and hold the button you wish to program on the Homelink system (I, II, or III). While holding the button, simultaneously press and release the corresponding button on the remote control. The Homelink indicator light will flash slowly at first, then rapidly. Keep holding the button until the indicator light starts flashing rapidly.c. Release both buttons. The Homelink system should now be in programming mode.
  5. Program the Homelink system with the garage door opener:a. On your garage door opener, locate the “Learn” or “Smart” button. This button is usually found on the motor unit near the antenna wire.b. Press the “Learn” or “Smart” button on the garage door opener and quickly return to your Honda Odyssey.c. Within 30 seconds, press and hold the programmed Homelink button (I, II, or III) in your Odyssey for a few seconds, then release it. Repeat this step two more times. On the third press, the garage door should activate, indicating that the programming is successful.
  6. Test the programmed button: Press the programmed Homelink button in your Honda Odyssey to test if it opens or closes the garage door. If it doesn’t work, repeat the programming steps and make sure you’re within range of the garage door opener.
  7. Repeat for additional garage doors (if applicable): If you have multiple garage doors or devices to program, repeat steps 5a to 5c for each device using a different Homelink button (I, II, or III).

Overall, according to Garage Door Repair Palm Desert CA, it’s important to note that the exact steps for programming the garage door opener in a Honda Odyssey may vary slightly depending on the model year and specific features of your vehicle. Therefore, it’s always a good idea to consult the owner’s manual or contact Honda customer support for precise instructions tailored to your vehicle model and year.

Palm Desert Garage & Overhead Doors

73210 Shadow Mountain Dr #3, Palm Desert, CA 92260, United States

760-654-6091