Resetting an Xtreme Garage Door Repair Opener is a straightforward process that can be completed in just a few steps. By following these instructions carefully, you’ll be able to reset your garage door opener and restore it to its factory settings.

Before starting the reset process, make sure you have the necessary tools and equipment, including a ladder, a flathead screwdriver, and the instruction manual for your specific model.

  1. Safety first: Before attempting any work on your garage door opener, ensure that the power is disconnected to prevent any accidental injuries. Locate the power source for your garage door opener and unplug it from the electrical outlet.
  2. Clear the memory: To reset your Xtreme Garage Door Opener, you’ll need to clear its memory. Look for the “Learn” or “Program” button on the opener’s main unit. This button is typically located near the antenna wire or on the back of the unit. Press and hold the “Learn” or “Program” button for about 10 seconds until the indicator light turns off.
  3. Access the remote control: Next, you’ll need to reset the remote control that operates your garage door opener. Open the battery compartment on the back of the remote control and remove the batteries. Leave the batteries out for about 30 seconds to ensure a complete reset. This step is crucial to ensure that the remote control is ready to be reprogrammed.
  4. Reprogram the remote control: After the 30-second interval, reinsert the batteries into the remote control. Stand within range of the garage door opener (usually within 20-30 feet) and press the “Learn” or “Program” button on the main unit once. The indicator light should turn on, indicating that the unit is in programming mode.
  5. On the remote control, press and hold the button you want to use to operate the garage door. This button could be labeled as “Open,” “Close,” or another suitable designation. Hold the button down until the indicator light on the main unit blinks, usually for about 2-3 seconds. This process associates the button on the remote control with the garage door opener.
  6. Test the remote control: To ensure successful programming, test the remote control by pressing the button you just programmed. The garage door should respond by opening or closing. If it doesn’t, repeat steps 4 and 5, ensuring that you’re within range of the main unit.
  7. Resetting additional remote controls and keypads: If you have additional remote controls or keypads that need to be reset, repeat steps 3 to 6 for each device. Remember to remove the batteries, wait for 30 seconds, and reinsert them before programming.
  8. Resetting the opener’s limits and force settings (optional): In some cases, you may need to reset the limits and force settings on your Xtreme Garage Door Opener. Consult the instruction manual for your specific model to determine the exact procedure for doing this, as it may vary. Usually, it involves adjusting the limit screws on the main unit using a flathead screwdriver.
  9. Restore power: Once you’ve completed the necessary resets and reprogramming, restore power to the garage door opener by plugging it back into the electrical outlet. The unit should be ready for regular operation.

Remember, these instructions are general guidelines, and the specific steps may vary depending on your model of Xtreme Garage Door Repair Opener. Consult the instruction manual that came with your device for detailed instructions tailored to your specific unit. If you encounter any difficulties or are unsure about any step, it’s always recommended to contact the manufacturer’s customer support for further assistance.

Atlas Door Company

6817 Sundance Cir W, Joshua, TX 76058, United States

1-817-295-3660