Replacing a Garage Door Repair Fort Worth TX spring can be a challenging task, but with the right tools and knowledge, it can be done safely and effectively. In this guide, we’ll walk you through the steps of replacing a garage door spring.

Before starting, it’s important to note that garage door springs are under a lot of tension and can be dangerous to work with. If you’re not confident in your ability to replace a garage door spring, it’s best to hire a professional.

Tools you will need:

  • Replacement garage door spring
  • Winding bars
  • Socket wrench set
  • Adjustable wrench
  • Safety glasses
  • Gloves

Step 1: Determine the Type of Spring

There are two types of garage door springs: torsion and extension. Torsion springs are located above the garage door, while extension springs are located on either side of the door. Before you start, determine which type of spring you have.

Step 2: Release Tension from the Spring

Before you can remove the spring, you need to release the tension. This is done by using winding bars to loosen the tension on the spring. Insert the winding bars into the holes on the winding cone, and turn the bars to loosen the spring. Make sure to wear gloves and safety glasses, as the spring can snap back and cause injury.

Step 3: Remove the Spring

Once the tension is released, use a socket wrench set to loosen the set screws on the spring cones. Remove the screws and slide the spring off the shaft.

Step 4: Install the New Spring

Install the new spring onto the shaft, making sure it’s centered and the end is pointing towards the door. Use the socket wrench set to tighten the set screws on the spring cones.

Step 5: Wind the New Spring

Using the winding bars, wind the new spring until it has the same number of turns as the old spring. Make sure to wind the spring in the correct direction – if you’re not sure which way to wind it, consult the manufacturer’s instructions.

Step 6: Test the Door

Once the new spring is installed and wound, test the garage door to make sure it opens and closes smoothly. If the door is still not working properly, you may need to adjust the tension on the spring.

Step 7: Dispose of the Old Spring

Garage door springs are made of steel and can be recycled. Contact your local recycling center to see if they accept steel springs.

In conclusion, replacing a Garage Door Repair Fort Worth TX spring can be a challenging task, but with the right tools and knowledge, it can be done safely and effectively. Remember to always wear gloves and safety glasses, and if you’re not confident in your ability to replace a spring, it’s best to hire a professional.

Fort Worth Garage Door Experts TX

817 Currie St, Fort Worth, TX 76107

817- 242-5868