Garage door springs are one of the most important components of your garage door system. They help to counterbalance the weight of the door and allow it to open and close smoothly. When a garage door spring breaks, it can be a major inconvenience and a safety hazard.

In this article, we will discuss how to repair a garage door spring according to Garage Door Repair Chandler AZ.

Before we get started, it’s important to note that garage door spring repair can be dangerous and should only be attempted by experienced individuals. If you’re not comfortable performing the repair yourself, consider hiring a professional garage door technician.

Step 1: Identify the Problem The first step in repairing a garage door spring is to identify the problem. There are two types of garage door springs: torsion springs and extension springs. Torsion springs are located above the garage door and are typically mounted on a metal shaft. Extension springs are located on either side of the door and stretch or expand to counterbalance the weight of the door.

If you hear a loud bang or notice that the door is crooked or uneven, it may be a sign that one of the springs has broken. You may also notice that the door is difficult to open or close, or that it makes a grinding or squeaking noise when in use.

Step 2: Release Tension from the Spring Before attempting to repair a garage door spring, it’s important to release the tension from the spring. This can be done by disconnecting the garage door opener from the door and manually lifting the door until the spring is fully extended. Be sure to use caution when lifting the door, as it will be heavy and may be difficult to control.

Step 3: Remove the Broken Spring Once the tension has been released from the spring, it’s time to remove the broken spring. If you have a torsion spring, use a winding bar to loosen the set screws on the winding cone. Then, slide the spring off of the shaft and remove it from the bracket. If you have an extension spring, use a pair of pliers to remove the safety cable from the extension spring. Then, use a socket wrench to loosen the bolts that hold the spring in place. Once the bolts are removed, slide the spring off of the bracket.

Step 4: Install the New Spring After the broken spring has been removed, it’s time to install the new spring. If you have a torsion spring, slide the new spring onto the shaft and tighten the set screws on the winding cone. Be sure to wind the spring in the correct direction, as specified by the manufacturer. If you have an extension spring, slide the new spring onto the bracket and secure it in place with the bolts. Then, reattach the safety cable to the spring.

Step 5: Test the Door Once the new spring has been installed, it’s time to test the door to make sure that it is operating smoothly. Reconnect the garage door opener to the door and test the door to ensure that it opens and closes smoothly and without any sticking or jerking.

Additional Tips:

  • It’s important to replace both springs at the same time, even if only one of them has broken. This will ensure that the door is properly balanced and will prevent future problems.
  • When installing a new spring, be sure to use a spring that is the same size and rating as the old one. Using the wrong size or rating of spring can cause damage to your garage door system.
  • If you’re not comfortable repairing a garage door spring yourself, consider hiring a professional garage door technician to perform the repair for you.

In conclusion, as per Garage Door Repair Chandler AZ, repairing a garage door spring can be a challenging task that requires experience and caution. By following the steps outlined above, you can ensure that your garage door is properly repaired and operating safely and smoothly.

Acclaim Garage Door of Chandler

184 E Chilton Dr, Chandler, AZ 85225, United States

480-545-0538