Programming the Temple Garage Door Repair feature in your Subaru involves a systematic process to synchronize your vehicle with your garage door system.

This comprehensive guide will walk you through each step, ensuring a successful and hassle-free programming experience.

: Gather Necessary Information

Before starting the programming process, gather essential information, including your garage door opener’s remote control and any access codes required for programming. Additionally, make sure you have access to the garage door opener motor unit, as you may need to locate a “Learn” or “Program” button.

: Locate the Homelink Buttons in Your Subaru

In your Subaru, the Homelink buttons are typically located on the ceiling near the rearview mirror. These buttons are designed to integrate with various home automation systems, including garage door openers.

: Clear Existing Codes (if applicable)

If there are any existing codes programmed in your Homelink system, it’s a good idea to clear them before proceeding. This ensures a clean slate for programming your garage door opener. To clear existing codes, press and hold the outer two Homelink buttons (often referred to as button 1 and button 3) for about 20 seconds until the indicator light starts blinking rapidly.

: Turn the Ignition On

Ensure that your Subaru’s ignition is in the “On” position. You don’t need to start the engine, but the ignition should be active.

: Press and Hold a Homelink Button

Choose one of the Homelink buttons you want to program for your garage door opener. Hold down the chosen button until the indicator light starts flashing slowly. This process might take around 20 seconds.

: Release the Buttons and Test

After the Homelink indicator light starts flashing slowly, release both buttons. Now, grab your garage door opener remote and press the button you want to program into the Homelink system. Return to your Subaru and press the programmed Homelink button. If the garage door responds by moving, the programming was successful.

: Repeat for Additional Doors or Buttons

If you have more than one garage door or want to program additional buttons for different devices, repeat the process using a different Homelink button for each device.

: Program Home Automation Systems (if applicable)

If your garage door opener is part of a larger home automation system, you might need additional steps to integrate it fully. Refer to the user manual of your home automation system or consult the manufacturer for specific instructions.

: Final Testing

After programming, conduct a final test by pressing the programmed Homelink button to ensure the garage door opens or closes as expected. Repeat this process for each programmed button to confirm all devices are functioning correctly.

: Troubleshooting (if needed)

If you encounter any issues during the programming process or the garage door doesn’t respond as expected, consult the Homelink troubleshooting section in your Subaru’s owner’s manual. It might provide specific guidance for common issues.

: Secure Your Vehicle

Once you’ve successfully programmed your Subaru’s Homelink system, ensure the vehicle is securely parked, and the garage door opener remote is stored in a safe location.

You’ve now successfully programmed your Subaru’s Temple Garage Door Repair using the Homelink feature, providing you with the convenience of controlling your garage door directly from your vehicle. If you encounter any challenges, refer to the owner’s manual or contact Subaru’s customer support for assistance.

Temple Overhead & Garage Doors

1079 Spring Terrace Loop, Temple, TX 76502, United States

1-817-813-6380